PERISCOPE DEPTHWHYARIUM NO. 95
← WHYARIUM
COMPARTMENT 03 · STEEL AGAINST THE SEA

Pressure Hull

Every ten metres of seawater adds about one more atmosphere of pressure. Take a hull down and see what that means for every square metre of steel, and how deep each kind of boat could go.

Hull test · press downSurface
Depth0 m
On one square metre0 t
On a fingernail (1 cm²)0 kg
On a 60 cm hatch0 t
020040060080010001200SEA PRESSUREBAR
Hull built for

Squeeze drawn hugely exaggerated. A steel hull shrinks by only a few centimetres at its test depth. Our boat's collapse depth is a toy number; real ones are secret.

Ten metres, one atmosphere

Air presses on everything with about one bar. Seawater adds roughly another bar for each ten metres of depth, so at 100 m the hull feels about 11 bar: a tonne on every 10 square centimetres, or 100 tonnes on every square metre of steel.

The crew inside breathe air at ordinary pressure the whole time. It is the hull, and only the hull, that stands between them and the sea.

Test depth and collapse depth

Test depth is the deepest a boat is allowed to go in normal service. Collapse depth (or design depth) is where the hull is expected to fail. Navies keep a big margin between them: the US Navy sets test depth at about two-thirds of design depth (so collapse is about one and a half times deeper), the Royal Navy at four-sevenths and the German Navy at one half.

These ratios come from one Wikipedia article and vary by era; WWII German literature quotes a safety factor of about 2.5 over construction depth for the Type VII. Exact figures for modern boats are classified.

Cylinders and spheres

A warship's pressure hull is a long cylinder stiffened by a ring of frames every half metre or so, because a cylinder carries people and machinery. A sphere spreads the load most evenly of all, so deep submersibles put their crew in a ball: Trieste's was steel, about two metres across, with walls about 12 cm thick at its thickest; Alvin's is now titanium.

Single hull, double hull

SINGLE HULLCASINGDOUBLE HULLBALLASTBETWEEN

In a single-hull boat the pressure hull is the outside of the boat for most of its length, and the ballast tanks sit at the ends. A double-hull boat wraps a light outer hull round the pressure hull and carries ballast between them. That gives more spare buoyancy on the surface (about 25–35%, against 10–15% for single-hull boats) and a buffer against damage, at the cost of size, weight and noise.

Other compartments